The concept of BIF 6040 is a display without menu; This provides direct and simplified access to
parameters setting.
The intuitive configuration allows an easy programming for decimal point position, alarms setting, analogue output calibration and linearization functions. BIF 6040 accepts input signal from a BAMOFLU (up to 30 kHz) and counters M series.
Scaling is assumed, entering a scale factor, to display total volume in the desired unit (m³; l; else), or instant flow rate in volume per hour, minute or second. Display switches from total volume to flow rate through a single push button.
A scan rate setting allows damping of transient phenomena in order to obtain a stable display.
The microprocessor allows the end-user to modify the range and the calibration
frequency directly from the front plate.
The saved settings are protected by a locking-switch on the rear panel of the
device.

Input frequency: 0.03 ... 30 000 Hz
Input signal type: NPN, PNP, potential free contact (mV level selectable)
Accuracy Frequency: ± 0.01 % of input at 25°C
Delay: ± 100 pulse/min / °C
Display: 6 Digits; Red LEDs; 14.2 mm high, High brightness; Decimal point setting
Counter reset Through external potential free contact or through keyboard
Safeguard On EEPROM (10 years)
Operating temperature: 0 ... +50 °C
Housing: Panel mounting, 48 x 96 mm, DIN,
Terminals: DIN / EN 50027,
Front: IP 65

OPTIONS: PCB extra for thresholds

• 2 alarms (code 282 202) or
• 4 alarms (code 282 204)
• Analogue output 4-20 mA (flow-rate)